Meranti window install

Finished Product, Work in progress

This morning we removed an old rotten window at a rugby club. The original was a 4 panel awning window (so it could wind out), but the client wanted fixed panels instead.

WE reduced it 2 panel fixed lite.  None of the sashes could be opened at this point – all had swollen from moisture and had sealed themselves shut.

Original Window. THe Right most panel has the glass ready to fall out as the bottom of the sash is comopletly rotten and sagging.

THe sashes have been removed and the mullions cut to then allow the rest of the perimeter frame to come out.

New frame in. Very tight working conditions on the inside.

Finito. Notice the bottom sill tiles have come away (they were resting on original frame). The Builder has a tiler organised to re-cement back in the correct angle. Our work is complete.

Advertisements

A few more photos

Finished Product, Work in progress

Im not in the office much lately – too many installs where im needed to give a hand. So here are just a few more photos of some of the things going on around now

Original and new timber flyscreen

Cedar casement windows ready for transport

a small selection of our frames in the factory today. an arch, a sliding door, some doorframes with sidelites etc.

Bay Window install

Finished Product, Uncategorized, Work in progress

Yesterday myself, Tom and Andrew installed this bay window (and another double window which ill add photos later).  The original window was rotting away and falling apart.  White cathedral glass on top colonial sashes, clear laminate on bottom panels. Sides are fixed/dummy sashes with the middle panel able to be lifted up (screens not in photo but sit on outside.)

Cedar bay window

Aluminium install

Uncategorized

This morning we removed 2 rotten timber framed louvre windows and replaced them with our aluminium residential sliding windows.  Flange and angle to finish, with some timber beading to go on the inside. i left the lads to finish the job once we had the larger one screwed in.  The owner was pretty happy and has asked us to quote for more along the side of the house.

Removing rotten wooden timbers and replacing with aluminium

Bifold install

Finished Product, Work in progress

We made some commercial aluminium windows and bifolds for a client.

They installed the windows, but asked us to come down and install the bifolds properly.

So Here are 2 photos of the bifolds i installed this morning.

manufactured and installed by THE WINDOW MAN

Black aluminium bifolds installed today

We will glaze the frames at a later date – double glazed units.

Wall cut and timber Bifold Window install

Finished Product, Work in progress

Last week three of us worked in Glenelg, installing some aluminium sliding windows, and the main task – a wall cut and install of a timber bifold window with timber servery bench. A lintel was used in this process.

some photos showing a brick wall being cut and bifold installed.

The inside is then finished with a bullnose sill, quads inside and out and the mortar from the bricks re-done.

Timber install photos

Finished Product

Last week we pulled out the old rotten windows in a lovely sun room. the floor was hand made parquetry, truly time-consuming to make.

We replaced the frames with new cedar frames. This time with no colonial bars, and increased the glass from 3mm float, to 6.38 clear comfort plus Low-E glass.